![]() ![]() This is a simulator for the popular, series capacitor, parallel inductor T-network tuners. Written by AE6TY for use with OS X, Windows, and Linux. ![]() In connection with the Ham Radio Logger RumLogNG or WSJT-X Rotor can control your antenna direction fully automatically.Ī Java-based application for development of Smith charts. It is able to track stations and satellites automatically with both azimuth and elevation and currently supports SPID, Yaesu (GS-232A/B), DCU-1 and Eas圜omm rotor protocols. Rotor is a full-featured antenna rotor control app for macOS. It takes you step by step through the design of a variety of antenna types including Dipole, Fat Dipole, Yagi, J-Pole and more. RF Toolbox (formerly Antenna Master) is an antenna design electronics/electrical tool package. ![]() It displays in real-time Solar Flux, A-Index, K-Index, and much more. ![]() Is a simple and fast app that allow you to calculate the loss of your coax line and calculate power output from your antenna system.ĬocoaNec is a Mac OS X application intended primarily for the design and modeling of antennas.ĭX Toolbox gathers information from the web on solar and geomagnetic conditions that affect radio propagation. Computer Connector: USB 1.1/2.0/3.0 Compatible Standard USB 'A'.Antennas, Transmission lines, Propagation If they are too low, then the SignaLink USB will NOT transmit. SignaLink USB are set according to the RX Audio/Spkr - 3.5mm Mono Setting The Audio Levels procedure in this manual. Most customers will want to attach the unit to the back of the radio (Data or Accy Port), as this will allow the microphone to stay plugged in. The SignaLink TM USB works with virtually ALL radios and can be attached to the Mic jack, Data Port or Accessory Port. I would recommend using the SignaLink USB with another rig and instead use the TS-590SG USB connection and the correct drivers for you Mac system to support virtual COM ports for CAT control (they will be found on the Silicon Labs web site). If you use the TigerTronics SignaLink USB, configure the jumper wires within the SignaLink USB for the radio connector(s) you are using, then just plug in the USB end into the USB port on the Mac, and the radio connector(s) end into the radio. Audio/PTT Interface using the SignaLink USB. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |